02-13-2008 10:01 AM - edited 03-05-2019 09:08 PM
Platform : C6506, 2xSUP720-3B, 122-33.SXH1
Linecards : SW-X6516(2),6516A(2).SSO on.
Command : show fabric
Resp : switching Mode = CROSSBAR for Mod 1,2,3,4,6- dCEF for mod 5 - Where can I find some explanations about CROSSBAR in 122SX ? I know crossbar for.. computers .
Furthermore I don t have dCEF hw-card ??
Best Regards
FF
02-13-2008 04:09 PM
Have some time? Take a look at this document:
HTH,
__
Edison.
02-18-2008 03:07 AM
Hi,thanks very much for the doc, my pb follows :
Ive 2 C6506(1edge-1campus)each has 2Sup720-3B
2 Eth-Gb-links (one Ipv4,one Ipv6),then end of Whitney1.O,122-33SXH+SSO running,OK.Then SXH1 installed on both.Now when I run SXH1 I get ONLY incoming streams(outside) AND no outcom.
from edge therefore no Internet access.In spite of the fact that eBGP peerings (between edge and NR)and iBGP between the 2 C6k are OK.
On edge Sup720 are HW 5.4,Fw 8.4(2).
On campus Slot5:Hw 5.3,Fw 8.5(1), Slot6 like above.Do you have any idea ? Thanks in advance
Regards
Francois
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: