intervaln routing

Unanswered Question
Feb 13th, 2008

How to configure intervaln routing on 4507 switch.suppose in the network 2,3,4,5 vlans are exist.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
s.arunkumar Thu, 02/14/2008 - 00:32


Since the switch is a layer 3,just create an svi for each vlan,and give one ip corresponding to each vlans subnet.

Eg:vlan 10 -

vlan 20 -

interface vlan 10

ip address

interface vlan 20

ip address


Rick Morris Thu, 02/14/2008 - 13:46

to go along with this each port on the switch when you assign the VLAN make sure you use the correct IP as the default gateway for the host/server connected. The DG is the IP assigned to the VLAN.

Rick Morris Thu, 02/14/2008 - 13:47

you will also need to make sure IP Routing is enabled.

from CLI

in conf t mode

ip routing

This places the switch into layer 3 mode.


This Discussion