I am trying to do the failover configuration on the FWSMs (version 3.1(1) and little confused with a statement on the Cisco's configuration guide...
As I understand to configure failover I need to specify the Active and Stanby IP addresses to the failover link using the following command:
"failover int ip if_name ip_addr mask standby ip_addr"
In Cisco's guide there is a note stating the following: "Do not configure an IP address for the failover link or state link if you are going to use stateful failover"
Yes, I do want to use stateful Failover for the Active/Standby setup...
Can someone tell me how do I configure without specifying the IP address to the failover link in a stateful, Active/Standby setup??
Thanks in advance