We have an AS5300 that is currently utilized as for our PPP dialup clients. We recently installed a new Cisco phone system so we would like to route the PRI that was strictly used for dial in access to our regular local hunt group of PRI circuits. To do this I am trying to run a T1 crossover cable from controller 4/0/0 on the 3845 to controller t1 1 on the AS5300. The PRI from ATT is connected on 4/0/1, and is up and registered in call manager. I cannot get the link to come up between the 3845 and the AS5300. The 3845 is the unit that interfaces with CallManager via MGCP. Here is my configuration for both:
3845:
controller T1 4/0/0
framing esf
clock source internal
linecode b8zs
pri-group timeslots 1-24 service mgcp
interface Serial4/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn protocol-emulate network
isdn T310 120000
isdn bind-l3 ccm-manager
no cdp enable
AS5300-
controller T1 1
framing esf
clock source line secondary 1
linecode b8zs
pri-group timeslots 1-24
interface Serial1:23
no ip address
encapsulation hdlc
dialer-group 1
isdn switch-type primary-ni
isdn incoming-voice modem
Any advise would be very much appricated.