Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1193
Views
0
Helpful
2
Replies

input errors only on 4500

plavine
Level 1
Level 1

‎02-14-2008 07:43 AM - edited ‎03-05-2019 09:09 PM

I am getting only input errors? What can cause this? I am using nic load balancing across two 4500's could this be an issue?

Here is an example output of sh int

0 runts, 0 giants, 0 throttles

263 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

Labels:
0 Helpful
2 Replies 2

mchin345
Level 6
Level 6

‎02-20-2008 09:44 AM

Make sure proper settings ( trunk and mode ) enabled between the 4500 switches.

Use Ethernet Configuring and Troubleshooting Ethernet 10/100/1000Mb Half/Full Duplex Auto-Negotiation

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml

0 Helpful

plavine
Level 1
Level 1
In response to mchin345

‎02-20-2008 10:39 AM

how would that affect the switchport a host is plugged into? The trunk port does not have errors on it, ONLY the host ports.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card