Multicast

Unanswered Question
Jon Marshall Thu, 02/14/2008 - 14:38
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Ali


It depends on whether you want to use Auto-RP or not.


If you don't and you just want to statically configure the RP address on all multicast routers then yes you are correct you do not need the "ip pim send-rp-announce int scope 16" command.


As for "no ip pim dm-fallback" this stops the router falling back to dense mode if there is no RP for a group. So if your RP that you statically configure is responsible for all groups you'll be fine.


Jon



Actions

This Discussion