show DMVPN

Unanswered Question
Feb 15th, 2008
User Badges:

Newbie question: how do I enable "show DMVPN". It appears from below that it needs to be "enabled". I am using a variety of IOS and they all don't appear to have the command. Thanks


show dmvpn

To display Dynamic Multipoint VPN (DMVPN) specific session information, use the show dmvpn command in privileged EXEC mode.


show dmvpn [peer [nbma | tunnel {ip-address}] | [network {ip-address} {mask}]] [vrf {vrf-name}] [interface {tunnel number}] [detail] [static] [debug-condition]


Command Default

This command is not enabled.


Command Modes

Privileged EXEC


Command History

Release Modification

12.4(9)T

This command was introduced.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
iraban Tue, 02/19/2008 - 07:10
User Badges:

what version of the IOS are you running

Richard Burts Tue, 02/19/2008 - 10:02
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Jeff also posted this question in the Network Infrastructure WAN Routing and Switching forum where it has been successfully resolved as a version (and code train) problem. For details see that thread in the WAN forum.


HTH


Rick

Actions

This Discussion