Configure WIC Adsl in corporate router for Internet connectivity

Unanswered Question
Feb 16th, 2008
User Badges:

I have the following scenario:

We have a Cisco 2811 router in my HO which is used for corporate data network.

All the branch offices connect to this router through an MPLS data network.


Now, I would like to give some of the users access the Citrix Web interface.

I will add one WIC ADSL in the 2811 router for this purpose only, which

will be connecting to internet. It has public IP also.


Now, How do i configure the 2811 router to address this scenario? How do I give access the internet users and corporate users to the server (citrix) without changing the default gateway of the webserver?


Please provide me a step by step configuration to setup the WIC and routing as i dont have enough experience in Cisco


Thanks for any input.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Sun, 02/17/2008 - 03:35
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi,


first of all, if you don't have experience in cisco, you need to hire someone that does, else it will be very difficult for you to get it working.


Then, on the router connected to the internet, you forward some ports to the internal server. And the default gateway of it, must have default route to said internet router.


In any case, write back when you have the hardware and the circuit working.

basheerpt Sun, 02/17/2008 - 05:02
User Badges:

Thanks P.B,

I have working knowledge on cisco routers but when it comes complicated configurations I need a push.


The WIC ADSL is inserted and shows OK, Please advise what to do next, as mentioned.


Regards

Paolo Bevilacqua Sun, 02/17/2008 - 05:27
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Have you been given an username/password for the DSL ? Or a static address perhaps ?


basheerpt Sun, 02/17/2008 - 05:39
User Badges:

Yes, its done. both pap and chap has given and CD is ok.

Paolo Bevilacqua Sun, 02/17/2008 - 10:04
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Let's try first with PPPoA that has no MTU reduction:


int atm0

pvc x/y <-- You need to know vp/vc values

encapsulation aal5mux ppp dialer

dialer pool-member 1


interface dialer 0

dialer pool 1

dialer-group 1

ip address negotiated

ip nat outside

ppp pap sent-username xxx password zzzz

ppp ipcp dns request

ppp ipcp default route


int fa0/0

ip nat inside


dialer-list 1 protocol ip permit


ip nat inside static tcp 80 interface dialer 1 8000


Note you must be able to ping citrix from router for this to work.


basheerpt Sun, 02/17/2008 - 22:44
User Badges:

Hi P.b,

I already have three dialer interfaces (ADSL) which is used to connect branch offices. So should i change , dialer, pool, group numbers to 3?


Is that all configurations have i to apply? Please provide if anything left in your previous post. I am going to apply the changes and test it today evening, while the users are out.


Thanks again


Paolo Bevilacqua Mon, 02/18/2008 - 02:48
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Where do you have the dialer interfaces ? Do you have other dsl interface in the same router ?

The config should be enough to let people acces internal web server from outside.

basheerpt Mon, 02/18/2008 - 04:35
User Badges:

The other interfaces are in same router. I have three dsl wics on it. The new one will be forth.

Paolo Bevilacqua Mon, 02/18/2008 - 04:52
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

So yes you need a new dialer interface to keep setting separate.

basheerpt Mon, 02/18/2008 - 05:11
User Badges:

Thanks, so it will be dialer3 and bridgegroup 3, right?


basheerpt Sat, 02/23/2008 - 00:56
User Badges:

Dear p.b,

where will i put the DNS server addresses for this internet connection? which interface?

Paolo Bevilacqua Sat, 02/23/2008 - 05:17
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi,


do not worry about putting any DNS server for this connection, router doesn't need DNS.

basheerpt Sat, 02/23/2008 - 07:12
User Badges:

The 'ppp ipcp default route' command doesnt accept in the dialer interface.

Actions

This Discussion