1310 with AIR-ANT24120 has a weak Signal

Unanswered Question
Feb 17th, 2008
User Badges:

I have two building 150 meters away;

one 1310 + air-ant24120

one 1310 internal patch antenna

I cannot align antennas even;

they are directly see each other

they are 150 meters avay

I am not sure "antenna gain" parameters

here is the config of (1310 + air-ant24120)

interface Dot11Radio0

no ip address

no ip route-cache


encryption key 1 size 128bit 7 xxx transmit-key

encryption mode ciphers aes-ccm tkip wep128


broadcast-key change 1800 membership-termination capability-change



ssid xxx


antenna transmit right

antenna receive right

antenna gain 28

channel 2427

station-role root bridge

bridge-group 1

bridge-group 1 spanning-disabled

service-policy output ATA-SES


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Sun, 02/17/2008 - 15:31
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

All I can say is make sure the antenna connections are on tight. Also, what is the cable length from the antenna to the 1310 and what type of cable?


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode