MGCP PRI Outbound Busy

Unanswered Question
Feb 18th, 2008
User Badges:

I did a firmware upgrade which went without issue. However, after it was done, the facility stated that they were not able to make outbound calls, inbound worked fine.


I did a no mgcp, and that resolved the issue. My question is: Should I treat this as coincidence or could it have to do with the firmware upgrade having an adverse affect on the callmanager?


The upgrade consisted of 141 phones.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Mon, 02/18/2008 - 12:34
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

i don't believe the issue was due to the firmware since they run over a whole different protocol, phones SCCP, GW MGCP.


What was the status of the GW under CUCM? registered, unregistered, unknown?

Did you gather a debug isdn q931 to look at the reason code for the disconnect?


HTH

Actions

This Discussion