Cat 500 24LC and which 4 ports are POE

Unanswered Question

I must be having a thick moment. Are all the ports on the 24LC capable of POE but the limitation is that the switch can only support 4 ports due to power max at 60w?

Also, is the way to set POE on a port to set the port to an Access Point? The whole Smartport concept is very limiting.

I want to run IP Camera's on POE, but can't seem to find any reference to how to set a port to POE other that as an AP.

Any points would be appreciated.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aijaz802 Mon, 02/18/2008 - 22:40


AFAIK there is no need to configure the power settings, it will auto detect. You need to specify the port type as AP while configuring the switch. The AP & IP camera power settings will be same.

You can go thru the following links for configuring the smartport types.

I hope it helps...pls rate if it solves ur issue.




This Discussion