02-18-2008 03:52 PM - edited 03-05-2019 09:13 PM
It seems you cannot enter " ip load-sharing per-packet " on a layer 3 Vlan interface on a 3750. Is this correct and if so, is there a way to configure load sharing on a per packet basis with EIGRP on a 3750?
02-22-2008 02:00 PM
1.To enable per packet load balancing for all IP traffic, enter the ip load-sharing per-packet command in interface configuration mode and enter the epc xpif-ip-per-pack-all global configuration.
2.To enable per packet load balancing for TCP traffic only, enter the ip load-sharing per-packet command in interface configuration mode and ensure the epc xpif-ip-per-pack-all global configuration command is not entered.
Make sure you are running minimum 12.1(10)E
02-25-2008 05:50 AM
Neither command seems to be a valid command on a 3750 with 12.2(25)SEE2.
02-25-2008 06:30 AM
Steve,
You are correct, that command isn't supported in these switches:
If you want to load-balance per-packet, you must configure Layer2 or Layer3 etherchanneling.
HTH,
__
Edison.
02-25-2008 06:35 AM
Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: