×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Strange Script Error (cisco.com.dialog.PlayPromptDialog is not supported)

Unanswered Question
Feb 18th, 2008
User Badges:

Hi:

I changed the aa.aef script (included in the CRS) as follow:


Start

Accept(--Triggering Contact)

PlayPrompt (--Triggering Contact, welcomePrompt)

callContact = PlaceCall(to "4041)

[successful branch]

PlayPrompt (callContact, welcomePrompt)


I debug the script in reactive mode and execute it step by step.


The first PlayPrompt and the call to 4041 execute without problem. But when I try to PlayPrompt on the callContact the following error occurs:


cisco.com.dialog.PlayPromptDialog is not supported


The strange is that I can send DTMF tones to the callContact (SendDigits step), but when I try to use PlayPrompt or GetDigits steps on the callContact it fails.


Any clues?

thanks in advance,

marcelo


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
BCOLE2007 Tue, 02/19/2008 - 10:57
User Badges:
  • Bronze, 100 points or more

What does properties in your Call Contact Step look like?


Marcelo-Rocha Tue, 02/19/2008 - 15:34
User Badges:

callContact is a variable of type Call Contact. The Place Call step has the following properties:


Destination = "4010"

Timeout = 10

Call Control Group ID = 1

Call Contact = callContact (variable to place the call)


Actually, the Place Call take effect (the 4010 terminal rings), but when I pick up the phone and the next step execute (PlayPrompt) there it fires the error:

"com.cisco.dialog.PlayPromptDialog is not supported". I must to note that the PlayPrompt step execute to the outbound call (4010) is the same I executed first in trigger contact. The first executes well but the secont (outbound call) fails.

BCOLE2007 Tue, 02/19/2008 - 15:51
User Badges:
  • Bronze, 100 points or more

Did you add an ID for a Dialogue group?

BCOLE2007 Tue, 02/19/2008 - 18:09
User Badges:
  • Bronze, 100 points or more

I am able to recreate this error message in Reactive debug. When I remove the ID in the Dialogue Group, the script will validate , but it seems to be required when doing voice,


I seem to remember a send DTMF will work without the dialogue group though....


please let me know how it goes




Marcelo-Rocha Wed, 02/20/2008 - 12:43
User Badges:

That's right, I did not set the dialog group. I'm going to test it on friday and post a comment.


Yes, I can send DTMF without set that parameter but both steps (PlayPrompt and GetDigits) fail. Both use PlayPrompt.


thank you for your support.

Marcelo

Marcelo-Rocha Thu, 02/21/2008 - 15:16
User Badges:

OK, I test it including a Dialog Group and it works without any problem.

BCOLE2007 Fri, 02/22/2008 - 04:57
User Badges:
  • Bronze, 100 points or more

Cool glad it works


I would really appreciate it if you could rate this help?


thanks

Actions

This Discussion