CLID from H323 gateway with CM 6.0.1

Unanswered Question
Feb 19th, 2008

Hi

I am using a router with a PRI in it setup as a H323 gateway for PSTN access. It works fine but when a user answers an incoming call the phones don't display the calling number.

I can see that BT are sending the CLID (debug ISDN Q931) but the 7900 phones don't get it.

Is there a setting in CM 6.0.1 or in the IOS config that needs to be changed to enable CLID on incoming calls ?

Thanks

Pat

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Patrick Colbeck Thu, 02/21/2008 - 02:32

Just to follow up on this. The PSTN provioder (BT) had disabled caller id ! When I initially tested it Caller ID was working but at some stage they have disabled it and it no longer shows up in the Q931 debug. So it's not a Cisco issue.

Actions

This Discussion