Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
623
Views
0
Helpful
1
Replies

Creating L2TP tunnel

Go to solution
GRIMESI
Level 1
Level 1

‎02-19-2008 09:28 AM - edited ‎03-03-2019 08:46 PM

Is there a way to create an l2tp tunnel between two routers, without using encryption or vpn? I just need to extend a layer 2 network for multicast traffic. thanks.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
shivlu jain
Level 5
Level 5

‎02-19-2008 10:29 AM

Grimes

You can do this with the help of PSEUDOWIRE and XCONNECT

Router# pseudowire-class abc

Router(config-pw)# encapsulation l2tpv3

Router(config-pw)# ip local interface loopback 0

int fa0/0.10

encapsulation dot1q 10

Router(config-if)# xconnect peer-router-id vc-id encapsulation l2tpv3 pseudowire-class abc

regards

shivlu

View solution in original post

0 Helpful
1 Reply 1

Go to solution
shivlu jain
Level 5
Level 5

‎02-19-2008 10:29 AM

Grimes

You can do this with the help of PSEUDOWIRE and XCONNECT

Router# pseudowire-class abc

Router(config-pw)# encapsulation l2tpv3

Router(config-pw)# ip local interface loopback 0

int fa0/0.10

encapsulation dot1q 10

Router(config-if)# xconnect peer-router-id vc-id encapsulation l2tpv3 pseudowire-class abc

regards

shivlu

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card