i have STM-1 card STM-1 Port Adapter (PA-MC-STM-1) on router cisco 7206 & i need to divide it according to the following:
1-one PVC that carry 40Mbps net(without framing).
2-another PVC that carry 40Mbps net(without framing).
3-the third PVC will carry the remaining BW of the STM-1
Note:when searching in the configuration guide i found that :
RTR(config-controller)#aug mapping au-3
& au-3 contain 21 TU-12s each with 2Mbps
so the net is 42 Mbps , which i neeed,but is the 42Mbps is net traffic(i mean is this without header?)because i need 40Mbps net,so could any one provide me a sample configuration of the scenario needed?