Rob Huffman Wed, 02/20/2008 - 08:00
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Ricardo,


Hope all is well with you! Here is the method to reverse the process and change the AP back to Autonomous Mode :)


Reverting the Access Point Back to Autonomous Mode


http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html#wp161272


You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco IOS Release that supports autonomous mode (Cisco IOS release 12.3(7)JA or earlier). If the access point is associated to a controller, you can use the controller to load the Cisco IOS release. If the access point is not associated to a controller, you can load the Cisco IOS release using TFTP.


Using a TFTP Server to Return to a Previous Release


Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release using a TFTP server:



--------------------------------------------------------------------------------


Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.


Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.


Step 3 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, and c1240-k9w7-tar.default for a 1240 series access point.


Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.


Step 5 Disconnect power from the access point.


Step 6 Press and hold MODE while you reconnect power to the access point.


Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.


Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.


Step 9 After the access point reboots, reconfigure it using the GUI or the CLI.


From this doc;


http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html#wp161272


Hope this helps!

Rob



Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode