cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
311
Views
0
Helpful
1
Replies

1242 Radio Config changes

nshoe18
Level 1
Level 1

I have a numbers of 1242 that when we set them up we used the GUI to configure them. Now we have gone back and seen that the channels we assigned to them are no longer there. They are now set back to Least Congested Channel instead of the assigned channel fo 1 6 or 11. Anyone else run into this?

1 Accepted Solution

Accepted Solutions

Rob Huffman
Hall of Fame
Hall of Fame

Hi Nicholas,

I have read about this happening. Perhaps you can use the CLI instead;

This doc shows the IOS commands;

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_15_JA/configuration/guide/s15rf.html#wp1037361

Hope this helps!

Rob

View solution in original post

1 Reply 1

Rob Huffman
Hall of Fame
Hall of Fame

Hi Nicholas,

I have read about this happening. Perhaps you can use the CLI instead;

This doc shows the IOS commands;

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_15_JA/configuration/guide/s15rf.html#wp1037361

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: