02-20-2008 09:09 AM - edited 03-15-2019 04:58 AM
Hello,
How do I have to do to configure E1's using MGCP on a catalyst 6513 with a "WS-SVC-CMM" module?
Thanks
02-20-2008 10:43 AM
Device -> gateway -> Add New -> Cisco Catalyst 6000 E1 Voip Gateway -> Next
the config on the module is almost the same as with a T1, it just changes the voice-port number that gets created and the pri group timeslots as well
How to Configure MGCP with Digital PRI and Cisco CallManager
HTH
02-21-2008 04:18 AM
When I add such a gateway in the CCM admin, it requires a MC address.
What's this MAC address and how could I find it?
02-23-2008 12:33 PM
Sorry, my bad, you need to select when adding the GW Communication Media Module and not CAT 6000 E1. The option i mentioned was for a 6608 and not for a CMM. if it was a 6608 then it would be the MAC from the port you will use
HTH
02-20-2008 10:55 AM
Hi Francois,
As nicely noted by Jaime, the majority of cnfig is done on CCM itself :) Here are some related docs;
Adding Gateways to Cisco CallManager
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_0_1/ccmcfg/b06gtway.html#wp1311093
Adding a Cisco IOS MGCP Gateway
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_0_1/ccmcfg/b06gtway.html#wp1311169
How to Configure MGCP Gateway Support for Cisco Unified Communications Manager
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf1.html#wp1047217
Catalyst 6500 Series and Cisco 7600 Series Communication Media Module Installation and Verification Note
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_14107.html
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: