Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
327
Views
4
Helpful
3
Replies

incoming call config on VIC2-2BRI-NT/TE

cfajardo1_2
Level 1
Level 1

‎02-20-2008 09:35 AM - edited ‎03-15-2019 04:59 AM

ive installed VIC2-2BRI-NT/TE module on my voice gateway where my cme/cue resides.

OBJECTIVE;

-Incoming call will connect directly to an extension 100 but after 5 rings is finished, then it shoud procced to the cue auto attendant 101.

Anyone help me for the configuration please

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎02-20-2008 09:39 AM

voice-port x/y/z

connection plar 100

ephone-dn 100 dual-line

number 100

call-forward noan 101 timeout 30

You can simplify configuration by placing common call forward settings under an ephone-dn-template, and apply the latter to all or groups of ephone-dn's.

Hope this helps, please rate post if it does

cfajardo1_2
Level 1
Level 1
In response to paolo bevilacqua

‎02-20-2008 11:23 PM

what about the isdn part..

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to cfajardo1_2

‎02-21-2008 10:30 AM

Only define tei-static 0 if necessary. All rest is default.

0 Helpful
Customers Also Viewed These Support Documents