I need to upgrade a Cisco 7206 VXR with a new image but I have not done thi sbefore and I don't know if the process is any doifferent from other samller routers. I appreciate if someone could point me to th esteps reqquired to do this upgrade. Also, i have DS3 card on this router currently functioning and I don't know if I need to upgrade the Microcode for this DS3 as well or not.
the imgae i.e. the IOS for the router is 6 years old and it goes the same for the DS3 card.
here is the current show version:
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-JS-M), Version 12.1(6), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Wed 27-Dec-00 11:14 by kellythw
Image text-base: 0x60008950, data-base: 0x61A14000
ROM: System Bootstrap, Version 12.1(20000914:181332) [bwhatley-npe200 102], DEVE
BOOTFLASH: 7200 Software (C7200-BOOT-M), Version 12.0(10)S, EARLY DEPLOYMENT REL
EASE SOFTWARE (fc1)
csvartr01 uptime is 1 year, 41 weeks, 2 days, 5 hours, 42 minutes
System returned to ROM by power-on
System image file is "slot0:c7200-js-mz.121-6.bin"
cisco 7206VXR (NPE200) processor (revision B) with 114688K/16384K bytes of memor
Processor board ID 20403669
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
6 slot VXR midplane, Version 2.0
Last reset from power-on
Last reset from power-on
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
8 Channelized T1/PRI port(s)
125K bytes of non-volatile configuration memory.
4096K bytes of packet SRAM memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .D unknown FFBFD838 685080 21 6705152 Jan 16 1917 23:20:57 c7200-js-mz.
2 .. image 4FB18F20 109F28C 21 10592652 Jan 16 1917 23:32:56 c7200-js-mz.
3 .. config 8A1CA895 10A0BF4 14 6375 Jun 29 1918 02:07:56 startup-conf
3273740 bytes available (17304564 bytes used)
I really apprecite anyhelp you guys can extend.
The best that you can get with your current processor is SSH version 1. NPE-200 is not supported beyond 12.2(15)T. Check the following url:
Addendum To EoS/EoL Notice For NPE-200 And Cisco 7206 Router Chassis
Feature Set: ENTERPRISE IPSEC 3DES
Image Name: c7200-jk9s-mz.122-15.T16.bin
DRAM / Min Flash : 128 / 20
Do rate if this helps!