Trying to set up a PPP T1 in a lab from one 1760 to other

Unanswered Question
Feb 21st, 2008
User Badges:

Trying to set up a PPP T1 in a lab from one 1760 to another 1760 using VWIC 2MFT T1 cards. This is driving me nuts, It will not let me set the timing. I would think at least one end has to have the timing set to internal. When I do the clock source or clock anything from the controller interface it says Invalid Input. ? shows no clock command. Code is 12.4(18)


Here is what I have configured so far:


controller T1 0/0

framing esf

linecode b8zs

channel-group 0 timeslots 1-24


and



interface Serial0/0:0

ip address 100.100.100.2 255.255.255.252

encapsulation ppp


Lastly, does anyone have a decent sample config for these? What I am trying to do is setup a voice lab. I have 2 1760's connecting to 2 3500 XL w/Inline power. All I want is to plug in a phone on either end and place a call. I have never worked with voice before and it's driving me nuts. Every page I seem to find on Cisco's web send me a different direction. I I could just see a config and find out what I need I could get it done.


Thank you very much


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion