MGCP GW doesn't send CONNECT_ACK

Unanswered Question
Feb 21st, 2008
User Badges:

Hi,


I've a CUCM 5.1 with an MGCP GW. This GW makes a QSIG connection on a PABX. In very specific situation, I can see that my GW does not reply to a CONNECT isdn message and does not send a CONNECT_ACK.


Is there a command to force this on the Cisco GW?


Thanks

jp

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pcameron Fri, 02/22/2008 - 07:15
User Badges:
  • Cisco Employee,

An ISDN Q931 connect should always be replied to with a connect ack. What is the 'very specific situation' you refer to that causes this problem ? Do you have a debug isdn q931 log that shows the messages - if so, please paste here.

jconi Sun, 02/24/2008 - 08:07
User Badges:

Thabks for the answer.

The very sporadic situation is a call to an analog bipper system connected on an analog trunk on the PBX.

It appeared that the problem was a misocnfiguration on the PBX, but of course, as it's not my PBX, I can't have the real cause of the problem.

Anyway, I still don't understand why my GW didn't reply with CONNECT_ACK.

rgds

jp

Actions

This Discussion