Performance Monitor

Unanswered Question
Feb 21st, 2008

I want to configure Performance monitor for PIX firewall. But I am not able to configure. Getting errors.


I am only able to configure it for concentrator but not for PIX.


I will be very greatful to you. Also tell me how to clear the error devices from cisco performance monitor and configure emial notification.


My firewall configuration:



TDC-INT-525-01# sh run | in snmp

snmp-server host inside 172.28.32.50 community ciscoworks123

no snmp-server location

no snmp-server contact

snmp-server community ciscoworks123

snmp-server enable traps snmp authentication linkup linkdown coldstart

snmp-server enable traps syslog


TDC-INT-525-01# sh run | in domain

domain-name default.domain.invalid

domain-name default.domain.invalid


Kindly also the attachment for the following errors that i m getting in performance monitor.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Wed, 02/27/2008 - 13:47

Make sure to provide the ip address of the server where you have MCP installed. Use the command pix(config)# snmp-server host . Set the SNMP community string to public.

wasiimcisco Wed, 02/27/2008 - 14:56

Thanks for the reply. I have configured all the required parameters. infact MCP that version is not supported by pix.


Thanks for the reply.

Actions

This Discussion