02-21-2008 12:41 PM - edited 03-05-2019 09:17 PM
all our switches are in vtp transparent mode, do I need to issue the delete flash:vlan.dat to clear the configuration or just erase start?
Solved! Go to Solution.
02-22-2008 09:22 AM
correct.
02-21-2008 12:53 PM
You havent specified the switch models, but typically you could use the following;
erase nvram to delete all files in nvram.
erase const_nvram to delete vlan database
erase startup-config to delete startup config
HTH
If so, please rate this post.
Thanks
Victor
02-21-2008 03:47 PM
Yes, delete vlan.dat.
02-22-2008 06:45 AM
Actually, you must specify the switch because it varies.
To erase the vlan.dat file on the 6500/6000 switches, issue the erase const_nvram: command. On the 4500/4000 switches, issue the erase cat4000_flash: command. On the fixed configuration switches, issue the delete flash:vlan.dat command.
HTH
Victor
02-22-2008 08:36 AM
The switches in question are 3750 and 3560 so I am guessing the delete flash:vlan.dat is required.
02-22-2008 09:22 AM
correct.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide