02-21-2008 02:44 PM
I'm seeing CiscoWorks update the Archive based on the following changes in the configuration. When I do a compare of configs is says that the clock period has changed???
ntp clock-period 36028913
Is this normal, I'm not too sure what this command really does?
Solved! Go to Solution.
02-21-2008 05:01 PM
This command should be ignored by config archive. However, we have seen some instsnaces where certain device classes did not have this command in their list of excluded commands. It's easy to fix. Go to RME > Admin > Config Mgmt > Exclude Commands, and add "ntp clock-period" to the list of excluded commands for this device type.
The typical list for IOS devices is:
end,exec-timeout,length,width,certificate,ntp clock-period
02-21-2008 05:01 PM
This command should be ignored by config archive. However, we have seen some instsnaces where certain device classes did not have this command in their list of excluded commands. It's easy to fix. Go to RME > Admin > Config Mgmt > Exclude Commands, and add "ntp clock-period" to the list of excluded commands for this device type.
The typical list for IOS devices is:
end,exec-timeout,length,width,certificate,ntp clock-period
02-22-2008 08:17 AM
good tip... thanks jclarke....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: