02-22-2008 05:08 AM - edited 03-05-2019 09:18 PM
I was trying to 'copy tftp flash' to a switch, after deleting the original IOS, due to reasons, that were beyond my control, I was unable to complete the task, and without thinking, I switched the switch off!! Bad move!! How can I sort this out: Error loading Flash......
The system is unable to boot automatically. The BOOT environment variable needs to be set to a bootable image.
TIA
Solved! Go to Solution.
02-22-2008 05:25 AM
OOOPS !! We have all been there in one form or another . This should get you sorted out.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
02-22-2008 05:25 AM
OOOPS !! We have all been there in one form or another . This should get you sorted out.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
02-22-2008 06:43 AM
Thank you very much - it's working (well it will be in 2 hours when it's finished downloading!!) :-)
02-22-2008 09:55 AM
Yeah you should done the speedup procedure where you set the console speed to 115200, it makes a huge difference , probably would take 15 minutes if you did .
02-25-2008 02:00 AM
I did read that after I started the process, and was too scared to quit while I was ahead!! Needless to say it all worked, the switch has resumed 'normality' and I'm a very happy teddy :-D
Thank you very much!
02-22-2008 05:47 AM
I think the above solution should solve your problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide