02-22-2008 05:08 AM - edited 03-05-2019 09:18 PM
I was trying to 'copy tftp flash' to a switch, after deleting the original IOS, due to reasons, that were beyond my control, I was unable to complete the task, and without thinking, I switched the switch off!! Bad move!! How can I sort this out: Error loading Flash......
The system is unable to boot automatically. The BOOT environment variable needs to be set to a bootable image.
TIA
Solved! Go to Solution.
02-22-2008 05:25 AM
OOOPS !! We have all been there in one form or another . This should get you sorted out.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
02-22-2008 05:25 AM
OOOPS !! We have all been there in one form or another . This should get you sorted out.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
02-22-2008 06:43 AM
Thank you very much - it's working (well it will be in 2 hours when it's finished downloading!!) :-)
02-22-2008 09:55 AM
Yeah you should done the speedup procedure where you set the console speed to 115200, it makes a huge difference , probably would take 15 minutes if you did .
02-25-2008 02:00 AM
I did read that after I started the process, and was too scared to quit while I was ahead!! Needless to say it all worked, the switch has resumed 'normality' and I'm a very happy teddy :-D
Thank you very much!
02-22-2008 05:47 AM
I think the above solution should solve your problem.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: