Multiple DNs 7911 CM 6.1

Unanswered Question
Feb 22nd, 2008
User Badges:

We are running CM 6.1 and I am wondering if its possible to configure a single line phone to accept more than one DN. I don't want to share a line, but just the DN. I keep finding CME information about "Shared Ephone DN" and that sounds like what I want, but I am not running CME. So basically I want a single line phone to ring for more than one extension.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Fri, 02/22/2008 - 12:39
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Ben,

Nice to see that you got the Licensing issue worked out :) In CCM you could create a CTI RP that points (via Call Forward) to the existing 7911 DN.

So, if the 7911 had DN 5530 and you also wanted the same 7911 to have DN 8888 ring there. Provided 8888 was not on any IP Phone or device you could create a CTI RP for 8888 that routes to 5530 via Call Forward All.

This is one method. Hope this helps!



This Discussion