ASA 5520 AIP-SSM 10 Confusion about Recover

Unanswered Question
Feb 24th, 2008
User Badges:

The same commands for recovering the config are the same for pulling a system image. Do you pull a system image or push a backup config?



To install the AIP-SSM system image, follow these steps:

Step 1 Log in to the ASA.

Step 2 Enter enable mode:

asa# enable

Step 3 Configure the recovery settings for AIP-SSM:

asa (enable)# hw-module module 1 recover configure

Note If you make an error in the recovery configuration, use the hw-module module 1 recover stop

command to stop the system reimaging and then you can correct the configuration.

Step 4 Specify the TFTP URL for the system image:

Image URL [tftp://0.0.0.0/]:

Example:

Image URL [tftp://0.0.0.0/]: tftp://10.89.146.1/IPS-SSM-K9-sys-1.1-a-6.0-1-E1.img

Step 5 Specify the command and control interface of AIP-SSM:

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion