static route

Unanswered Question
Feb 25th, 2008

How to configure two static routes for the same network but different ports one for ethernet and other for the BRI on the same router?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
shivlu jain Mon, 02/25/2008 - 21:34

you can do like the given

ip route fasetethernet0/0

ip route fasetethernet0/1 60

60 is the preference, as you are increasing the pref the route will be less prefered.So it will be your secondary route.



guruprasadr Mon, 02/25/2008 - 21:42


If it is the floating static routes use can use the increased AD as 200 for secondary Link.

ip route fasetethernet0/0

ip route fasetethernet0/1 200

Pls Rate all Informative Post

Best Regards,

Guru Prasad R

saimbt Wed, 02/27/2008 - 04:54

On a MEN, having a floating static route can give issues.

MEN connects to the router through a switch which in turn connects to the providers network through fiber. If there is a fiber cut at the provider's end, the connectivity between the router and the provider switch will still be UP and the routing entry for will still be reachable through f0/0

Traffic will never fall back on f0/1



This Discussion