Spectrum24 Client Bridge to LWAPP AP isnt working

Unanswered Question
Feb 26th, 2008
User Badges:

We have several GE MAC5000 EKG Carts that use a Spectrum24 Client Bridge (CB-1000-0000) that has a Symbol PCMCIA 802.11b card in it. These work fine with our autonomous APs but will not work on our new LWAPP wireless network. It does associate but if I look at the controller at the details of the client it shows an IP address of 0.0.0.0. These are statically assigned and I do not require DHCP for the WLAN it is associating to. Anyone have any ideas for me? Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
plandobait Tue, 02/26/2008 - 13:10
User Badges:

Are the CB-1000's showing up in the Client Exclusion List.


Are your LWAPP AP's using the same IP Scheme as the Autonomous AP's?


I have had problems with other Symbol gear (wireless barcode scanners) and Zebra wireless printers when trying to use static addresses once AP's were converted to LWAPP - I would get a similar situation that you are describing.


I ended up using DHCP but putting in a reservation for those devices with the IP address I wanted to use.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode