02-26-2008 11:31 PM - edited 03-10-2019 03:40 PM
Hi everyone,
I need your help !
I have ACS Solution Engine (ACSE) 3.3.
I have encountered the following symptom.
1:
User "ktaka" and "kina" have already existed/registered in ACSE local database.
I tried to change the password for both "ktaka" and "kina" by selecting each user then click "add/edit" button.
But all parameters (Supplementary User Information) for both users were emptied, that is, all parameters got back to factory default.
Have anyone met this symptom ?
Is it the bug ?
I researched Cisco Bug database, but I could not find any related defect.
2:
And then, I re-entered the appropriate parameters into empty field/information for both users and clicked/executed" submit" button.
3:
I executed the research begin the character "k" to confirm whether above 2: operation was successfully done.
But the result of research, two "ktaka" and two "kina" were found, that is, there are duplicated users in ACSE local database.
Have anyone met this symptom ?
Is it the bug ?
I researched Cisco Bug database, but I could not find any related defect.
Your information would be greatly appreciated.
Shinichi
02-28-2008 12:17 PM
To fix it use the dbcompact command via the serial console.
Here is the link for steps for running dbcompact.
Regards,
~JG
Do rate helpful posts
02-28-2008 05:57 PM
Hi,
Thank you very much for your reply.
I understand it and I will try dbcompact commnad.
Regards,
Shinichi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: