Caller_ID problem

Unanswered Question

I have a problem when receiving incoming call. The router strips the leftmost digit (0) off and present only the last 10 digits. for example when caller (0123465245) calls, only 123465245 appears on the cisco IP phone.


Can somebody advice me on what needs to be configured on the callmanger router to rectify this issue.


The following are the configs for the VOIP. I have also attatched Debug isdn 931 and sh trunk group outputs



trunk group Outgoing

translation-profile incoming addzero




!

voice translation-rule 300

rule 1 // /0/ type national national

rule 2 // /00/ type international international

!

!

voice translation-profile addzero

translate calling 300

!

!

!

dial-peer voice 150 voip

destination-pattern 5...

session protocol sipv2

session target ipv4:192.168.0.253

dtmf-relay sip-notify

codec g711ulaw

no vad

!

dial-peer voice 151 pots

description Incoming calls on BRI 0/0/0

incoming called-number .

direct-inward-dial

port 0/0/0

!

dial-peer voice 100 voip

!

dial-peer voice 152 pots

description Incoming calls on BRI 0/0/1

incoming called-number .

direct-inward-dial

port 0/0/1




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Wed, 02/27/2008 - 04:42
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, all seems configured correctly.


Can you try placing the voice translation-profile addzero, for incoming, directly under the voice-port.

paolo bevilacqua Wed, 02/27/2008 - 10:38
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Ok, can you try:

voice translation-rule 300

rule 1 // /0/ type national national plan isdn isdn



I have this setup in many install and it has always worked ?!?

Actions

This Discussion