Hi the version is: 1.1(3) as shown in the show module command output.

Regards,

Maurice

Hi Maurice,

I believe that is the HW rev and not the Software version of the CSM.

Just verify the show module output. The first number is the HW rev and the second is the SW rev like this:

7 0015.f998.a83a to 0015.f998.a841 1.8 <-- HW 4.1(5) <--SW Ok

In any event, you are probably hitting bug id CSCsd07524.

Regards

Pete..

Hi Pete, this is the output of the command:

CSUIORTP02#sh module

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX SAL1106GMAB

2 4 CSM with SSL WS-X6066-SLB-S-K9 SAD1113027E

5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1050AY20

6 2 Supervisor Engine 720 (Hot) WS-SUP720-3B SAL1052BZ1W

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 0019.304b.6020 to 0019.304b.604f 7.1 7.2(1) 8.5(0.46)ROC Ok

2 001a.a148.8f8a to 001a.a148.8f91 1.3 1.1(3) Ok

5 0013.c347.6650 to 0013.c347.6653 5.3 8.4(2) 12.2(18)SXE6 Ok

6 0016.c847.cfac to 0016.c847.cfaf 5.3 8.4(2) 12.2(18)SXE6 Ok

Mod Sub-Module Model Serial Hw Status

--- --------------------------- ------------------ ------------ ------- -------

5 Policy Feature Card 3 WS-F6K-PFC3B SAL1050AT88 2.3 Ok

5 MSFC3 Daughterboard WS-SUP720 SAL1050AY6R 2.6 Ok

6 Policy Feature Card 3 WS-F6K-PFC3B SAL1051BQS0 2.3 Ok

6 MSFC3 Daughterboard WS-SUP720 SAL1052BZW8 2.6 Ok