Hi all,
I have setup a new Cisco 851 router.
I have done the config via the CLI.
The router seems to work ok but If I connect to it via the com port and let it reboot I will see an error as below:
no ip dhcp use vrf connected.
The point it stops on is vrf.
I wanted to just remove this command but I am unable to do that.
I have tried to do it via the command line but usually I need to put no in front of the command, but this command already has a no in front of it.
This command is not in my config and I think the router put it in by itself.
Any help would be appreciated.