Upgrade stack members separately

Unanswered Question
Feb 28th, 2008
User Badges:

I'm trying to nail down this issue - is it possible to upgrade switch stack members individually, so as to minimise disruption.


eg.

upload software

set boot statements

reload switch 2

when switch 2 is up, reload switch 1


The upgrade guide assumes that you are upgrading the whole stack in one go, but is there anyway to force otherwise? I'm not sure there is, but it would be nice to be surprised!


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Thu, 02/28/2008 - 05:26
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Nathan


It is my understanding that unless you want to take a switch out of the stack there is not a way to upgrade single switches within the stack.


HTH


Rick

mark.j.hodge Thu, 02/28/2008 - 05:58
User Badges:
  • Bronze, 100 points or more

Remember, the entire stack is controlled by the Stack Master. So even if you upgrade the software on a stack member and reboot, it will not take effect unless that member becomes the master.



Actions

This Discussion