VIC2-2BRI-NT/TE configuration for Cisco 2851

Unanswered Question
Mar 2nd, 2008

Hello,


Do you have a sample configuration for VIC2-2BRI-NT/TE? This device is connected to a Cisco 2851 ISR and used for incoming and outgoing calls.


Thank you,

Ricky

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Mon, 03/03/2008 - 01:07

Hi, it depends on various things, which country are you in, do the lines have did? That just to begin with.

rickyhadlocon Mon, 03/03/2008 - 01:42

I spoke to soon. :) I have problems when i unplug the BRI circuits, the link is not turning up.


This is for our Osaka, Japan Office.


Below is my current config:


interface BRI0/0/1

no ip address

isdn switch-type ntt

no isdn spoofing

trunk-group BRI-trunks


Thank you.

Paolo Bevilacqua Mon, 03/03/2008 - 04:11

Hi, ISDN BRI by nature doesn't go down when unplugged. How many circuits do you have in trunkgroup ? There is a suggested config to work around that, but if you have one circuit only, isn't needed.

rickyhadlocon Mon, 03/03/2008 - 05:29

Thanks for your reply. I have 4 BRI circuits connected to these devices. All of them are member of the trunk group BRI-trunks.


What else am i missing?

Actions

This Discussion