Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
571
Views
0
Helpful
2
Replies

2.4 AP bridging to 5G for backhaul

Jed Renton
Level 1
Level 1

‎03-02-2008 10:33 PM - edited ‎07-03-2021 03:28 PM

An old CISCO AIRONET 1240AG SERIES 802.11A/B/G ACCESS POINT datasheet details using the 2.4 GHz radio as the AP and the 5GHZ radio for backhaul.

Repeater mode isnt used.

Is this a supported configuration as I cant find any configuration guides for it.

I am interested in both autonomous and LWAP options

thanks

Labels:
0 Helpful
2 Replies 2

irisrios
Level 6
Level 6

‎03-10-2008 07:04 AM

I guess by backhaul you mean bridge link. This is a supported configuration since configuration for each Radio can be defined seperately.

0 Helpful

Jed Renton
Level 1
Level 1
In response to irisrios

‎03-10-2008 03:34 PM

what I am concerned with is that I cant find a single example of this on CCO and this scenerio is removed from the latest version of the Datasheet (which was the only place that referenced it). Maybe it is a push to use mesh instead of bridging

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card