Jon Marshall Mon, 03/03/2008 - 02:34
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


You are getting this message because someone else is logged into the same device and has issued a "show config" at the enable prompt.


Their "show config" has not completed and until it does you will not be able to run your "show config".


If you type "who" at the enable prompt it will show you who else is logged in to the device.


HTH


Jon

Actions

This Discussion