Patching is not available since the system is not running from an installed

Unanswered Question
Mar 3rd, 2008
User Badges:
  • Silver, 250 points or more

I get the message in the conversation title when I enter the sh ver command "Patching is not available since the system is not running from an installed image. To install please use the "install file" command".

What should be done here?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Tshi M Mon, 03/03/2008 - 08:46
User Badges:
  • Silver, 250 points or more

I actually just installed this switch but it is possible that the previous owner downloaded and installed the software that you mentioned. How do I verify that he actually downloaded that software? Is there something that I need to do to either remove this from the sh ver output or complete the install? I used the "sh install run" but there were no output.

Edison Ortiz Mon, 03/03/2008 - 08:54
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

No verification is needed, you are running the Software Modularity code.


You can always go back to the regular code by downloading and installing, just like a typical upgrade.

Tshi M Mon, 03/03/2008 - 08:59
User Badges:
  • Silver, 250 points or more

I am a bit conrned because Solarwinds (monitor software) is showing the device using 92% of its memory. But, the show memory output has the following output:


System Memory: 524288K total, 252632K used, 271656K free, 1000K kernel reserved

Lowest(b) : 278147072

Tshi M Mon, 03/03/2008 - 11:00
User Badges:
  • Silver, 250 points or more

CPU utilization for five seconds: 4%; one minute: 4%; five minutes: 3%


I am baffled!!!

Edison Ortiz Mon, 03/03/2008 - 11:04
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Not sure where SolarWinds is getting that information then, contacting their tech-support should be the next course of action.


__


Edison.

Actions

This Discussion