Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
251
Views
0
Helpful
1
Replies

can a WiSM be connect to 2 DMZ anchor points for fail over ?

michael.lussier
Level 1
Level 1

‎03-03-2008 08:20 AM - edited ‎07-03-2021 03:28 PM

Can a WISM be connected to 2 different 4402 DMZ anchors on 2 different ISP for fail over senario. Without actually using one of them unless the other is down ?

Labels:
0 Helpful
1 Reply 1

sabhasin
Cisco Employee
Cisco Employee

‎03-08-2008 08:01 PM

I suppose this might be helpful:

http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6521/prod_bulletin0900aecd8070f198_ps6973_Products_Bulletin.html

Also, check the Enterprise Mobility 4.1 guide (chapter 10) for more information on how to setup this feature...

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns279/c649/ccmigration_09186a00808d9330.pdf

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card