Rob Huffman Mon, 03/03/2008 - 11:14
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Peter,


The 7936 is supported on CCM 5.0. What happens when it trys to boot up?


http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7936/firmware/3_3_15/english/release/notes/7936_3315.html


If you are trying this on a normal "voice" switchport it may not work. They don't seem to like the


access vlan

voice vlan


Just set;


switchport mode access


switchport access vlan xxx (where xxx is the voice vlan)


Let us know,

Rob

peternnaji Tue, 03/04/2008 - 06:29
User Badges:

Hi Rob,

I've been able to register the 7936 phone. But when I make an external call, there's a two-way commuinication, which is ok, but when an external call comes in, I can't hear the calling party but he hears me well (one way communication). Attached is the sh run. Pls help.



Attachment: 
Rob Huffman Tue, 03/04/2008 - 07:00
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Peter,


Well, we are getting there :) I don't have much experience troubleshooting this type of issue. I have read about the "bind command" as shown in this doc;


Troubleshooting One Way Voice Issues


http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml



Hope this helps!

Rob

peternnaji Tue, 03/04/2008 - 09:18
User Badges:

HI Rob,

The document seem to be complex as it does not give one particular solution to the "oe-way communication issue". I dont seem to get the right solution. ALl the same, I'll still try more.

Actions

This Discussion