03-03-2008 10:40 AM - edited 03-15-2019 09:11 AM
I am having issues in registaering a 7936 IP Phone on a CCM5.0. Is 7936 supported on CCM5.0?
03-03-2008 11:14 AM
Hi Peter,
The 7936 is supported on CCM 5.0. What happens when it trys to boot up?
If you are trying this on a normal "voice" switchport it may not work. They don't seem to like the
access vlan
voice vlan
Just set;
switchport mode access
switchport access vlan xxx (where xxx is the voice vlan)
Let us know,
Rob
03-04-2008 06:29 AM
03-04-2008 07:00 AM
Hi Peter,
Well, we are getting there :) I don't have much experience troubleshooting this type of issue. I have read about the "bind command" as shown in this doc;
Troubleshooting One Way Voice Issues
http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml
Hope this helps!
Rob
03-04-2008 09:18 AM
HI Rob,
The document seem to be complex as it does not give one particular solution to the "oe-way communication issue". I dont seem to get the right solution. ALl the same, I'll still try more.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: