cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
297
Views
4
Helpful
4
Replies

7936 conferencce phone doesnt register on CCM5.0

peternnaji
Level 1
Level 1

I am having issues in registaering a 7936 IP Phone on a CCM5.0. Is 7936 supported on CCM5.0?

4 Replies 4

Rob Huffman
Hall of Fame
Hall of Fame

Hi Peter,

The 7936 is supported on CCM 5.0. What happens when it trys to boot up?

http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7936/firmware/3_3_15/english/release/notes/7936_3315.html

If you are trying this on a normal "voice" switchport it may not work. They don't seem to like the

access vlan

voice vlan

Just set;

switchport mode access

switchport access vlan xxx (where xxx is the voice vlan)

Let us know,

Rob

Hi Rob,

I've been able to register the 7936 phone. But when I make an external call, there's a two-way commuinication, which is ok, but when an external call comes in, I can't hear the calling party but he hears me well (one way communication). Attached is the sh run. Pls help.

Hi Peter,

Well, we are getting there :) I don't have much experience troubleshooting this type of issue. I have read about the "bind command" as shown in this doc;

Troubleshooting One Way Voice Issues

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml

Hope this helps!

Rob

HI Rob,

The document seem to be complex as it does not give one particular solution to the "oe-way communication issue". I dont seem to get the right solution. ALl the same, I'll still try more.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: