03-04-2008 12:07 AM - edited 03-03-2019 08:57 PM
I have an E1 line that, when connected to a 2800, works ok (60 slipped seconds per interval.) But when connected to a 2600 series router:
E1 0/0 is up.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
No alarms detected.
alarm-trigger is not set
Version info Firmware: 20051006, FPGA: 20, spm_count = 0
Framing is CRC4, Line Code is HDB3, Clock Source is Internal.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (371 seconds elapsed):
6961 Line Code Violations, 30565 Path Code Violations
9 Slip Secs, 0 Fr Loss Secs, 367 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 371 Unavail Secs
Total Data (last 65 15 minute intervals):
224327 Line Code Violations, 1136313 Path Code Violations,
2992 Slip Secs, 0 Fr Loss Secs, 22493 Line Err Secs, 0 Degraded Mins,
3955 Errored Secs, 1372 Bursty Err Secs, 2638 Severely Err Secs, 20077 Unavailable.
It's running a compatible OS:
ROM: C2600 Software (C2600-IK9O3S3-M), Version 12.3(20), RELEASE SOFTWARE (fc2)
The Show Diag seems slightly off, but, should be a WIC-1-MFT-E1:
WIC Slot 0:HDB3, Clock Source
E1 (1 port) WAN daughter card-CONFIG_I: Configured from console by
Hardware revision 1.0 Board revision D0
Serial number 31595174 Part number 800-04475-03
FRU Part Number WIC/VIC-E1=
nhr-am-rt
=0/0:0
Interface
IOS (tm) C2600 Software (C2600-IK9O3S3-M), Version 12.3(20), RELEASE SOFTWARE Technical Support: http://www.cisco.com/techsupportam-
[64/16]
ping 217.149.33.210 repeat 20
Type escape sequence to abort.
Sending 20, 100-byte ICMP Echos to 217.149.33.210, timeout is 2 seconds:
!!!!!!!!!.!!.!!!!!!!
If I can award double points for this I will!
03-04-2008 02:26 AM
On the 2801, you need "network-clock-participate wic 0" and "network-clock-select 1 e1 0/0".
Are you sure you're receiving clock on this circuit ?
However there still too many errors and after the commands above you should have your circuit checked anyway.
03-04-2008 07:49 AM
It's a 2621. The 2800 works fine. Those commands don't seem to be present on the 2621, and it's just the one WIC.
03-04-2008 09:08 AM
On my 2611XM, I can enter network-clock-participate, are you sure you can't ?
03-06-2008 07:19 PM
In the general config mode, on my non-XM router 2621, there is not that command. Oh well, I'm replacing it with another 2800.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: