Show Config Command options

Unanswered Question
Mar 4th, 2008

I've got a 4507R that when I do "sho config" or "sho run" it outputs the entire configuration to the screen instead of one page at a time. Is there a way to fix this? Application buffer fills up and can't scoll up to what I need to see.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (2 ratings)
Loading.
Edison Ortiz Tue, 03/04/2008 - 14:23

Are you connected via the console to the redundant Supervisor? If so, that's an expected behavior. Connect to the active supervisor and the screen should stop one page at the time.

If that's not the case, then check your terminal settings.

Please post the output from typing show term

HTH,

__

Edison.

lamav Tue, 03/04/2008 - 14:49

JT:

At the privilege exec prompt (hostname#), type term len 30.

This will restrict the output to 30 lines at a time.

HTH

If so, please rate all helpful posts.

Victor

Actions

This Discussion