03-04-2008 02:03 PM - edited 03-05-2019 09:32 PM
I've got a 4507R that when I do "sho config" or "sho run" it outputs the entire configuration to the screen instead of one page at a time. Is there a way to fix this? Application buffer fills up and can't scoll up to what I need to see.
03-04-2008 02:23 PM
Are you connected via the console to the redundant Supervisor? If so, that's an expected behavior. Connect to the active supervisor and the screen should stop one page at the time.
If that's not the case, then check your terminal settings.
Please post the output from typing show term
HTH,
__
Edison.
03-04-2008 02:49 PM
JT:
At the privilege exec prompt (hostname#), type term len 30.
This will restrict the output to 30 lines at a time.
HTH
If so, please rate all helpful posts.
Victor
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide