2950 Interface admin down

Answered Question
Mar 5th, 2008

2950-01#sh ip int brief

Interface IP-Address OK? Method Status Protocol

Vlan1 unassigned YES NVRAM administratively down down

Vlan13 10.13.12.25 YES NVRAM up up

Vlan300 172.28.63.252 YES NVRAM administratively down down

Vlan310 172.28.64.252 YES NVRAM administratively down down

FastEthernet0/1 unassigned YES unset down down

FastEthernet0/2 unassigned YES unset down down

FastEthernet0/3 unassigned YES unset up up

FastEthernet0/4 unassigned YES unset down down

FastEthernet0/5 unassigned YES unset up up

FastEthernet0/6 unassigned YES unset down down

FastEthernet0/7 unassigned YES unset down down

FastEthernet0/8 unassigned YES unset down down

The problem with the above configuration is that when i noshut vlan 300, then vlan 13 goes administratively down.At a time only one interface out of the three (Vlan 13, Vlan 300, Vlan 310) remains up and active. No-shutting any interface results in the administratively down of all the other 2 interfces.

My version is

IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA8a, RELEASE SOFTWARE (fc1)

I have this problem too.
0 votes
Correct Answer by massimiliano.se... about 8 years 9 months ago

Hi,

With 2950 you can have only ONE VLAN active with assigned IP address.

2950 is a layer 2 device.

I hope this helps.

Best regards.

Massimiliano.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
massimiliano.se... Wed, 03/05/2008 - 02:27

Hi,

With 2950 you can have only ONE VLAN active with assigned IP address.

2950 is a layer 2 device.

I hope this helps.

Best regards.

Massimiliano.

aijaz802 Wed, 03/05/2008 - 03:00

Hi,

2950 is a layer-2 switch, only one vlan interface can be up at any time....You can't have multiple vlan interfaces in this switch.

HTH

Please rate if it helps...

*aijaz*

Actions

This Discussion