PIX 506E connection to Juniper and Symantec

Unanswered Question
Mar 5th, 2008

Hi all,

I'm looking for some words of wisdom here... I'm trying to connect a Cisco PIX 506E to a Juniper SSG-5 and a Symantec Gateway 320 via IPSec VPN over public internet, and nothing is happening. I know most people here may not know much about these other two products, but can anyone maybe point me in the right direction, or have any ideas as to why I can't get them to talk?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
didyap Tue, 03/11/2008 - 10:34

Check if you have configured the following properly:

1. Internet Key Exchange (IKE) proposal on both devices.

2. IPsec parameters on both devices.

3. Specify network ranges on both devices for the passage of traffic across the proposed tunnel.

patricio2626 Fri, 03/21/2008 - 07:42

Thanks for the suggestions. It turns out it was the rule order; I had a general 'allow' policy above the 'tunnel' policy on the other device, so it was trying to send that traffic unencrypted, and the packets with private IP address destinations were, of course, promptly dropped.



This Discussion